This carburettor kit is designed for highly tuned piston port cylinders and race engines. Due to its larger size, used on the right application, this carb will greatly improve the performance of your engine. Also due to it being a flatslide this will provide cleaner carburation as the slides surface area is smaller than the PHBH models, with around slide, meaning the highest point of depression is closer to the centre allowing better atomisation of fuel and a cleaner burn.
This carburettor can also be used with almost all exhausts and combined with a JL3 or JL4 can vastly improve your vehicle's performance and BHP.
This carb kit is designed to run under side panels with no need to cut holes.
Before sending out your carb kit we will re-jet the carburettor to roughly suit your application, cutting down on expensive guess work.
When setting up your carburettor we are always at the other end of the phone to help you with any questions or advice you may require so do not hesitate to give us a call. We also have a well equipped dyno facility so if you require further assistance and need the vehicle setting up please contact us for enquiries and bookings.
34mm carburettor, choke cable conversion, manifold, manifold rubber, jubilee clips, atomiser, pilot jet, needle, main jet, throttle cable, cable trunnion and inlet manifold gasket.
.jpg)
