The VHSH 30mm carburettor is a neat and compact flat slide carburettor that can be used on TS1 or piston port cylinders like the rapido 250cc, 225cc 0r 200cc and many other applications. Its smaller size can be an advantage if you have a long range fuel tank, it also benefits from a metal slide cap as opposed to the VHSB having a larger plastic one. This carburettor can also be used with almost all exhausts and combined with a JL3 or JL4 can vastly improve your vehicle's performance and BHP.
The advantage of a VHSH 30mm flatslide over a round slided carburettor like the PHBH is that because the slide is much smaller it means you get higher depression closer to the centre and therefore atomises the fuel into smaller molecules giving cleaner carburation. This will make a noticable improvement over a PHBH 30 and will be more responsive at lower RPM and will give you more drive out of the corner. And more importantly, with the constant rise in fuel prices, you will find this carburettor will be more fuel efficient than some of the larger carburettors.
This carb kit is designed to run under side panels with no need to cut holes.
Before sending out your carb kit we will re-jet the carburettor to roughly suit your application, cutting down on expensive guess work.
When setting up your carburettor we are always at the other end of the phone to help you with any questions or advice you may require so do not hesitate to give us a call. We also have a well equipped dyno facility so if you require further assistance and need the vehicle setting up please contact us for enquiries and bookings.
30mm carburettor, choke cable conversion, manifold, manifold rubber, jubilee clips, atomiser, pilot jet, needle, main jet, throttle cable, cable trunnion and inlet manifold gasket.
Note - this carb has been machined and modified to enable the correct mounting onto a PHBH rubber. If the carb is not machined, the carb will fall off when the engine gets warm.
.jpg)
