A complete carburettor kit for use with almost all cylinders from 125cc to 225cc. Due to its ease of setting up this carburettor is suitable for a wide variety of applications, including some reed valve cylinders. it also accomodates most exhausts and combined with a JL3 can greatly improve your vehicle's performance and BHP.
The advantages of running the PHBH open bell mouth is that it can be easier to setup and can slightly improve performance, however, there can be a small amount of spitback that can collect on the side panel and rear runner, if you have a nice spray job and this is a problem you can select the kit with the remote filter.
This carburettor is designed to fit under side panels with a need to cut a hole.
Before sending out your carb kit we will re-jet the carburettor to roughly suit your application, cutiing down on expensive guess work.
When setting up your carburettor we are always at the other end of the phone to help you with any questions or advice you may require so do not hesitate to give us a call. We also have a well equipped dyno facility so if you require further assistance and need the vehicle setting up please contact us for enquiries and bookings.
The complete kit includes:
28mm carburettor, choke cable conversion, manifold, manifold rubber, jubilee clips, atomiser, pilot jet, needle, main jet, throttle cable, cable trunnion and inlet manifold gasket.
.jpg)
